The stone cutting machine consists of a cutting knife set, a stone conveying platform, a positioning guide and a frame. The stone cutting machine is made of iron suitable for dry cutting, wet cutting all kinds of stone, building materials, ceramic tiles, granite, marble, cement board, red brick, fireproof. Bricks, etc., are essential tools for home decoration. The stone cutting machine can separately cut the stone materials at different depths, and can process the stone materials below 1m3, which can turn waste into treasure, greatly save stone resources and protect the environment. It can mechanically treat various types of stone materials. Cutting processing, high processing efficiency, combined with the effective use of small stone, the production cost is lower.

Pay attention to the following points when using the stone cutting machine:

1. Do not wear gloves. Wear a mask or face shield if it can cause dust during operation.

2. Do not attempt to cut small workpieces that are not clamped.

3. This cutting machine only allows cutting profiles.

4. Do not perform strong sawing operation, and make the motor reach full speed before cutting.

5. No one is allowed to stand behind the saw.

6. Do not lean over or bypass the saw machine. Do not loosen any hand or lift the arm from the saw or workpiece when the saw blade is not stopped.

7. Do not operate the guard when it is not in place. Do not place your hand within 15 cm of the saw blade.

8. Always turn off the power before servicing or replacing the accessories, and wait for the saw blade to stop completely.

9. If there is abnormal sound, stop checking immediately.