Introduction Of Working Principle And Performance Of Infrared Bridge Type Stone Trimming Machine
Feb 25, 2019

Infrared cutting machine, also known as infrared bridge type stone trimming machine, is mainly used for stone infrared cutting, numerical control infrared cutting, infrared glass cutting, infrared plastic cutting, roughly after cutting polished wool, plastic, glass, cement board, etc., according to the requirements of rapid, accurate and continuous cutting required standard specifications. It can be combined with thickness fixing machine, polishing machine and other equipment to form a production line. It can also be applied separately.

It is mainly used for stone infrared cutting, numerical control infrared cutting, infrared glass cutting, infrared plastic cutting. Our infrared cutting machine spindle lifting system uses four guide pillars. The following edition introduces the working principle of infrared bridge type stone trimming machine spindle lifting system.

The trawl of the infrared bridge type stone trimming machine is mounted on the beam. The guide sleeve and hydraulic cylinder are connected with the trawl. The guide column can slide up and down in the guide sleeve. At the same time, the upper part of the infrared bridge type stone trimming machine is connected with the support plate by bolts. The main motor is installed on the support plate of the infrared bridge type stone trimming machine.

红外线桥式修边机_副本

Infrared bridge type stone trimming machine belongs to high precision cutting machine, which needs special technicians to provide technical guidance and install according to the equipment procedure. In order to ensure the reliability of the construction period, the inspection must be carried out according to the specified indicators after installation. Infrared bridge type  trimming machine is mainly used to process semi-finished and finished slabs such as granite and marble. It is the most widely used equipment in stone processing, and also the equipment used in the last process of general engineering slab processing. AT below, Shandong Sambin Machine Co.,Ltd will introduce you the beam and longitudinal support of the infrared bridge stone trimming machine.

Beams. The crossbeam of the stone cutter is mainly subjected to its own gravity and the gravity of the main cutting device. It is also subjected to the vibration caused by two motors when working, and the stress situation is complex. The cross beam is cuboid in shape, large in size, with 9 reinforcement bars inside, and its structure is more complex. Using HT200 as a whole, the beam is required to have certain stiffness and strength, and its deformation is less than 0.12mm.

Longitudinal support. Longitudinal support bears only vertical force, which requires the longitudinal support to maintain a certain degree of parallelism and horizontality, with sufficient stiffness and strength, and its deformation should be less than 0.15mm. The processing accuracy of infrared bridge stone cutter directly affects the geometric size and accuracy of Engineering slabs. At the same time, the cutting mode of infrared bridge stone cutter is also directly related to the output of slabs. Material rate and processing cost.


Related News

24 hours at your service:

Scarlett@sambin.net

Contact Us

[[JS_BodyEnd]]